Publicidad
Idiomas disponibles
Idiomas disponibles
Inflating the Spa Air Bladder
1. Open the inflation valve and insert the inflation hose into the valve.
2. Slide the pump piston up and down to inflate until it is firm to the touch but not hard.
3. Disconnect the inflation hose from the valve, then close and push in the inflation valve.
NOTE: If you need to add some air to the spa tub wall or air bladder after they have been set up, please see the "Inflating the spa tub wall" section above or
refer to this "Inflating the spa air bladder" section again. The air bladder is preinstalled inside the spa cover in MONO / NAVAL models. If it needs to be
reinstalled, place the deflated air bladder inside the spa cover lip before inflating the bladder.
1-2.
Installing the Filter Cartridge
1. Attach the filter cartridge base to the spa tub inlet grid (upper position) and turn it slightly to secure. NOTE: The filter cartridge base is designed to be
screwed on and off. Never exert force as this could cause damage.
2. Attach the filter cartridge to the base.
NOTE: Inflate the spa tub first before installing the filter cartridge.
NOTE: Always use a filter cartridge when the spa is in use and filled with water.
Filling the Spa with Water
1. Before filling with water ensure the bottom drain valve cap is securely closed.
2. Fill the spa tub with fresh water to a level between MIN and MAX marked on the inside of the
spa wall.
WARNING:
Do not overfill the spa.
Do not operate the spa until the water reaches the MIN mark.
Never move the spa tub when there is water inside it and/or when the control box is attached, as
this may damage the spa or control box.
Never pour water with a temperature higher than 40 °C (104°F) into the spa directly. We recom-
mend that you fill the spa tub with lukewarm water to heat it more quickly and save energy. Use tap
water for spa filling to minimize the influence of unwanted content, such as minerals.
Heating the Water
1. Place the spa air bladder and spa cover over the spa tub, and make sure the spa cover buckles are locked.
2. Ensure the spa is plugged into an electrical socket and see the "ALL-IN-ONE CONTROL PANEL " section for further details on operation.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Base
3.
11
Lock
Unlock
Publicidad
