Publicidad
Idiomas disponibles
Idiomas disponibles
BUBBLE MASSAGE
BUBBLE button to turn the function on; hold down the BUBBLE button for 3 seconds to turn the function off.
Press the
BUBBLE
BUBBLE
The bubble setting can be adjusted to three different levels. The default setting is at level 2
the setting to level 3
IMPORTANT: Do not turn on the massage system when the cover is attached. Air can accumulate inside the spa and cause irreparable damage
and bodily harm.
NOTE: The bubbling massage function will shut down automatically after every 20 minutes of operation as a safety precaution. This can be
reactivated after 10 minutes by pressing the BUBBLE button again.
HEATING TIMER
To set the number of hours FROM NOW when the heater will activate:
TIMER
1-99H
1. Press the
TIMER button to enter pre-setting mode. The TIMER icon shown on the LED display.
TIMER
2. Pressing the
UP or
activation (from 1 to 99 hours). The desired timer setting will remain on the LED display for 3 seconds to confirm the value.
To modify the timer setting: Press the Timer button again and use the UP or the DOWN button to adjust.
Cancel the setting: Press the TIMER button for 3 seconds.
NOTE: Activating the heating system or rebooting the spa will cancel the timer setting.
UVC SANITIZER
Press the
UVC button to turn the UVC sanitizing system on/off. The UVC icon shown on the LED display means the UVC sanitizing system
is activated.
NOTE: The UVC emitter is built inside the control box. Therefore, the function can be turned on at any time, even with people inside the spa.
OZONE
Press the
OZONE button to turn the function on / off. The Ozone icon shown on the LED display means the function is activated. The
Ozonator will shut down automatically after operating for 2 hours.
NOTE: For bathers' safety concern, please do not soak in the spa when the Ozone is on. The Ozone function cannot be turned on when JET or
BUBBLE function is on. We suggest to turn on the function after using the spa.
SAFETY LOCK
+
Press the
UP and
3s
disabled and the spa retains all previous settings.
Celsius/Fahrenheit Toggle Button
The temperature can be displayed in either Celsius or Fahrenheit. Press the
options.
3s
(720W). Press it again to switch to level 1
DOWN button will cause the LED to flash. While it is flashing, you can adjust the number of hours before heater
DOWN buttons at the same time for 3 seconds to lock/unlock the controller. In safety lock mode, the controller is
(300W).
DOWN button for 3 seconds to toggle between the two
15
(500W). Press the BUBBLE button to switch
Publicidad
