Publicidad
Idiomas disponibles
Idiomas disponibles
Water Treatment:
●
It is good practice with an existing spa to keep all air jets open and valves closed to allow chemically treated water to flush through all pipework.
●
Always follow the chemical manufacturer's directions, and the health and hazard warning.
●
Never mix chemicals together. Add the chemicals to the spa water separately. Thoroughly dissolve each chemical before adding it to the water.
●
Please note that chlorine and bromine products should never be mixed. This is extremely dangerous. If you usually use chlorine-based products and
you want to switch to bromine-based products, or vice versa, it is essential that you change the spa water first.
●
Do not add chemicals if the spa is occupied. This can cause skin or eye irritation.
●
Do not overuse chemicals or use concentrated chlorine. This can damage the spa tub and cause potential hazard to your skin. Improper chemical use
will void the warranty.
DRAINAGE, CLEANING AND STORAGE
Spa Drainage
1. Turn off all the functions.
2. Connect the drain valve adaptor to a garden hose and point the other end of the garden hose to a suitable draining area.
3. Remove the drain valve cap from the outside of the spa tub and attach the drain valve adaptor to the drain valve.
4. On the inside of the spa tub, open the drain valve cap. Water will start flowing out from the garden hose.
5. When the water stops draining, lift the spa tub wall from the side opposite the drain, directing any remaining water to the drain and emptying the spa
completely.
6. Press the BUBBLE button to dry the spa pool.
7. Disassemble the control box. Pour out any water from the piping system.
8. Use a clean towel to wipe up any remaining water and moisture on the spa tub and spa control unit. Ensure the spa tub and spa control unit are
thoroughly dried.
2
3
(TUSCANY)
Cleaning The Spa Tub
If dirt is visible in the water or if the water becomes cloudy and the correct water chemistry does not clear it up, change the water and clean the spa tub. See
the "Spa tub drainage" section on how to drain the spa. While empty, clean and/or replace the filter cartridge. Use a sponge and mild soap solution to wipe
away any soil or stains on the inside of the spa wall. Rinse thoroughly before refilling with clean water.
IMPORTANT: Do not use steel wool, hard brushes or abrasive cleaners.
①
4
6
15
minutes
(MONO / NAVAL)
Deflation Instructions
Spa deflation (MONO / NAVAL)
1. Open the valve cap by twisting it counter-clockwise. Ensure the valve is clear from debris, sand, or dirt before
releasing.
2. Push the valve button in and turn it clockwise to lock it in the DOWN position.
3. Once deflation is completed, re-place the cap.
Spa Bladder Deflation
1. Open the valve cap to deflate the bladder. For quick deflation, insert the straw (included in the repair
kit) into the valve.
2. Once the deflation is completed, re-place the cap back.
7
BUBBLE
DOWN
17
5
8
Publicidad
