LG LWC3063BD Manual Del Propietário página 63

Symptoms
• The oven temperature is too high to set a Self Clean operation.
• Oven controls improperly set.
Oven will not Self
Clean
• A Self Clean cycle cannot be started if the oven lockout feature is active.
• Make sure to slide the tank into the slot until it clicks into place.
• This is the sound of the metal heating and cooling during both the cooking and
"Crackling" or
"popping" sound
• A convection fan may automatically turn on and off.
Fan noise
• Convection fan stops during a convection bake cycle.
Convection Fan stops
• This is normal. This means that the product has just been plugged in, or that it
Displayed Time is
flashing
• Excessive soil.
Excessive smoking
during a Self Clean
cycle
• Oven is too hot.
Oven door does not
open after a Self
• Allow about one hour for the oven to cool after the completion of a Self Clean
Clean cycle
• The control and door may be locked.
• Oven controls not properly set.
The oven does not
clean after a Self
• Oven was heavily soiled.
Clean cycle
• The Self Clean cycle has been selected, but the door is not closed.
CLEAN and door flash
in the display
• The oven door is locked because the temperature inside the oven has not
LOCKED is on in the
display when you
want to cook
• This is normal in a new oven and will disappear in time.
Burning or oily odor
emitting from the vent
• The shiny, silver-colored racks were cleaned in a Self Clean cycle.
Oven racks are
difficult to slide
Possible Causes / Solutions
- Allow the oven to cool and reset the controls.
- See the Self Clean section.
Self Clean functions.
- This is normal.
- This is normal.
- This is normal and is done to allow for more even heating during the cycle.
This is not a failure of the oven and should be considered normal operation.
has experienced a power interruption. Touch the Clock key and reset the time,
or touch any key to stop the flashing.
- Touch the Clear/Off button. Open the windows to rid the room of smoke. Wait
until the Self Clean mode is cancelled. Wipe up the excess soil and reset the
clean.
- Allow the oven to cool below locking temperature.
cycle. The door can be opened when the lock
- See the Self Clean section.
- Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens
may need to Self Clean again or for a longer period of time.
- Close the oven door.
dropped below the locking temperature.
- Touch the Clear/Off button. Allow the oven to cool.
- To speed the process, set a Self Clean cycle for a minimum of 3 hours. See
the Self Clean section.
- Apply a small amount of vegetable oil to a paper towel and wipe the edges of
the oven racks with the paper towel.
TROUBLESHOOTING
is no longer displayed.
63