LD Systems RSMP Manual De Usuario página 5

CAUTION:
1. Do not operate the device if it has been exposed to strong temperature
fluctuations (for example, after transport). Moisture and condensate could damage
the device. Do not switch on the device until it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains supply match the values
indicated on the device. If the device has a voltage selector switch, do not connect
the device until it is set correctly. Use only suitable power cords.
3. To completely disconnect the device from the power supply, unplug the power ca-
ble or power adapter from the outlet. It is not sufficient to press the on/off switch
on the unit.
4. Only replace the fuse with a fuse of the same type and rating indicated on the
device.
5. Make sure that suitable measures have been taken against overvoltage
(e.g. lightning strike).
6. Observe the specified maximum output current on devices with Power Out
connection. Ensure that the total current consumption of all connected devices
does not exceed the specified value.
7. Replace pluggable mains cables only with original cables.
DANGER:
1. Choking hazard! Plastic bags and small parts must be kept out of reach of persons
(including children) with reduced physical, sensory or mental capabilities.
2. Danger of falling down! Make sure that the device is securely installed and cannot
fall down. Only use suitable stands or mountings (especially for fixed installations).
Make sure that accessories are properly installed and secured. Make sure that
applicable safety regulations are observed.
WARNING:
1. Use the device only in the manner intended.
2. Operate the device only with the accessories recommended and intended by the
manufacturer.
3. During installation, observe the safety regulations applicable in your country.
4. After connecting the device, check all cable routes to prevent damage or accidents,
e.g. due to tripping hazards.
5. It is essential to observe the specified minimum distance to normally flammable
materials! If this is not explicitly stated, the minimum distance is 0.3 m.
CAUTION:
1. In the case of moving components such as mounting brackets or other moving
components, there is a possibility of getting jammed.
5