LD Systems RSMP Manual De Usuario página 6

CAUTION:
1. Do not install or operate the unit near any radiators, heat registers, stoves, or other
sources of heat. Always ensure that the device is installed in such a way that it is
sufficiently cooled and cannot overheat.
2. Do not place ignition sources such as lighted candles near the unit.
3. Ventilation openings must not be covered and fans must not be blocked.
4. Use the original packaging or packaging provided by the manufacturer for transport.
5. Avoid shocks or impacts to the device.
6. Observe the IP protection class as well as the ambient conditions such as
temperature and humidity according to the specification.
7. Devices may be subject to continuous development. In case of deviating
information on operating conditions, performance or other device characteristics
between operating instructions and device labeling, the information on the device
always has priority.
8. The device is not suitable for tropical climates and for operation above 2000 m
above sea level.
9. Unless explicitly stated, the device is not suitable for operation under marine
conditions.
NOTICE:
In the case of conversion or retrofit kits or accessories provided by the manufacturer,
be sure to follow the enclosed instructions.
CAUTION HIGH VOLUME AUDIO PRODUCTS!
This device is intended for professional use. Commercial operation of this device is
subject to applicable national regulations and guidelines for accident prevention.
Hearing Damage from High Volume and Continuous Exposure: Use of this product may
generate high sound pressure levels (SPL) that can cause hearing damage. Avoid
exposure to high volume levels.
SIGNAL TRANSMISSION AND CONTROL VIA RADIO
(E.G. W-DMX OR AUDIO RADIO SYSTEMS, BLUETOOTH):
The quality and performance of wireless signal transmissions is generally dependent
on the environmental conditions.
Influence on the range and signal stability have e.g.:
• Shielding (e.g. masonry, metal buildings, water).
• High radio traffic (e.g. strong W-LAN networks)
• Interference
• Electromagnetic radiation (e.g. LED video walls, dimmers)
• All range specifications refer to free-field application with line-of-sight contact
without interference!
• The operation of transmitters is subject to official regulations. These may vary from
region to region and must be checked by the operator before commissioning
(e.g. radio frequency and transmission power).
6