Publicidad
Idiomas disponibles
Idiomas disponibles
nOTE: If you are not sure which height to cut, begin mowing
with the cut height adjustment lever positioned towards
the rear.
To Set the Height of Cut
1. Pull the cut height adjustment lever out of the locking
notch
18
.
2. Move the lever towards the rear of the mower to raise the
height of cut.
3. Move the lever towards the front of the mower to lower
the height of cut.
4. Push the height adjustment lever into one of the
locking notches.
OPERATION
DANGER: To reduce the risk of serious personal
injury, turn unit off and remove the safety key and
battery packs before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
Proper Hand Position (Fig. A)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires both hands grasping the
main handle
4
and bail handle
self‑propel mode; and both hands grasping the main handle,
bail handle, and self drive bail handle
self‑propel mode.
READ THIS INSTRUCTION MANUAL BEFORE
OPERATING YOUR MOWER
Refer to Figure A at the beginning of this manual for
a complete list of components. Save this manual for
future reference.
DANGER: Sharp moving blade. Do not operate the
mower in mulching mode if the rear door is not closed
under spring tension as serious injury could result. Take
your mower to the nearest service center for repair.
DANGER: Do not operate mower unless handle is
locked into position.
DANGER: Sharp moving blade. Never operate the
mower in bagging mode unless the bag hooks on the
grass collection bag are seated properly on the mower
and the rear discharge door rests firmly against the top
of the grass collection bag as serious injury could result.
WARNING: Let the mower work at its own pace. Do
not overload.
Installing and Removing the Battery Packs
(Fig. I)
DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERIES.
5
together when not in
14
together when in
This mower is designed to operate on two battery packs
of equal capacity. The mower will not operate on a single
battery pack, and If using different capacity battery packs, the
smaller capacity battery pack, when depleted, will cause the
unit to turn off.
nOTE: For best results, make sure the battery packs
fully charged.
To Install the Battery Packs
1. Lift and hold the battery port cover
battery ports
19
.
2. Slide a battery pack
20
audible click is heard. Repeat for the second battery
nOTE: Ensure the battery packs are fully seated and fully
latched into position before starting mower.
3. Close the battery port cover. Ensure the cover is fully
closed before starting mower.
To Remove the Battery Packs
1. Lift and hold the battery port cover up to expose the
battery ports.
2. Depress the battery release buttons
packs and pull the battery packs out of tool.
Safety Key (Fig. J)
DANGER: Sharp moving blade. In order to prevent
accidental start‑up or unauthorized use of your
cordless mower, a removable safety key
incorporated into the design of your mower. The mower
will be completely disabled when the safety key has
been removed from the mower.
DANGER: Rotating blades can cause serious
injury. To prevent serious injury, turn unit off and
remove safety key and battery packs when unattended,
or when charging, cleaning, servicing, transporting,
lifting, or storing mower.
Starting Mower (Fig. I–K)
DANGER: Sharp moving blade. Never attempt
to override the operation of the switch box and
safety key system as serious injury could result.
nOTE: Mower is operational when battery packs and safety
key are installed.
1. Install battery packs
installing and Removing the Battery Packs.
2. Insert safety key
3
fully into the key port
is now operational.
3. To operate the mower, push and hold the ON‑OFF
button
2
on the ON‑OFF switch box
bail handle
5
to the main handle
nOTE: Once the mower starts, you can release the ON‑OFF
button, but you must continue to hold the bail handle to the
main handle for the mower to run.
4. To turn the mower OFF, release the bail handle.
WARNING: Never attempt to lock a switch or bail
handle in the ON position.
nOTE: Once the bail handle has returned to the original
position it will activate the "Automatic Braking Mechanism".
9
up to expose the
into the battery port until an
21
on the battery
3
has been
20
into mower as described in
22
. The mower
1
, then pull the
4
.
English
20
are
11
Publicidad
