Pioneer DCS-FS303K Manual De Instrucciones página 29

Speaker selection
Select a speaker that you want to adjust.
NOTE
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
Size – Since the speaker settings are fixed, you
cannot change the settings.
Volume – Press I i to adjust the output level
of the selected speaker.
Distance – After you connected speakers
to your unit, set the Distance between the
speakers and your listening point if the
distance of Center or Rear speakers is bigger
than the distance of Front speakers. This allows
the sound from each speaker to reach the
listener at the same time. Press I i to adjust
the Distance of the selected speaker. This
distance is equivalent to a difference of the
distance between Center or Rear speaker and
Front speakers.
Test – Press I i to test the signals of each
speaker. Adjust the volume to match the
volume of test signals memorized in the
system.
LOCK (Parental Control)
Initial Setting of the Area Code:
When you use this unit for the first time, you
have to set the Area Code.
1. Select the [LOCK] menu and then press i .
2. Press i .
To access the [LOCK] options, you must
input the password you have created. Input
a password and press  ENTER. Enter it
again and press  ENTER to verify. If you
make a mistake before pressing  ENTER,
press CLEAR.
3. Select the first character using U u buttons.
4. Press  ENTER and select the second
character using U u buttons.
5. Press  ENTER to confirm your Area code
selection.
Rating
Blocks playback of rated DVDs based on their
contents. Not all discs are rated.
1. Select [Rating] on the [LOCK] menu then
press i .
2. Input a password and press  ENTER.
3. Select a rating from 1 to 8 using the U u
buttons.
Rating 1-8 – Rating one (1) has the most
restrictions and rating eight (8) is the least
restrictive.
Unlock – If you select unlock, parental
control is not active and the disc plays in
full.
4. Press  ENTER to confirm your rating
selection.
Installation 29
3