Publicidad
Idiomas disponibles
Idiomas disponibles
• Leave the appliance on charge for at least 9 hours. While charging, the charger may
get warm, this is perfectly normal and safe. It is safe to leave the appliance connected
to the charger indefinitely. The charger
automatically reduces power consumption
when charging is complete.
• When charging is complete, the LED will
turn off.
WARNING:
charge the battery at ambient temperatures
below 39°F (4°C) or above 104°F (40°C).
Switching on and off (fig. E)
• To switch the appliance on, slide the on/off switch (4) forward to position I.
• To switch the appliance off, slide the on/
off switch (4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter
to remove dirt; however, in order to keep the
suction force optimized, the dust container
and filters must be cleaned regularly.
Cleaning the dust container and
filters (fig. F - J)
There are two methods of cleaning
the bowl, a quick empty method and a
thorough clean method.
For the quick empty method use the
following instructions.
• Press the release latch (6) and open the
container door (5) (fig. F).
• Empty the dust container (11).
• Close the dust container door (5). Make sure
that the release latch (6) clicks into place.
For the thorough clean method use the
following instructions.
• The dust container (11) is attached to
the body of the appliance. To remove the
dust container, press the dust container
release button (2) and rotate the dust
container (11) counterclockwise and
carefully slide the dust container clear of
the appliance.
• Remove the main filter (13).
• Brush any loose dust off the filter (12).
• To remove the pre-filter, rotate the pre-filter
Do not
Low Power Mode
5
D
E
F
n
Publicidad
