Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Troubleshooting
Issue - When returning to the iPod nano Main Menu after adjusting
the TuneBase FM settings, the iPod nano stays on the "OK to
disconnect" screen.
Solution - Remove your iPod nano from the TuneBase FM and reconnect. If
no longer using the TuneBase FM, simply remove and then reset your
iPod nano by pressing the "select" and "menu" buttons simultaneously
for 10 seconds.
Issue – The TuneBase FM does not appear to be saving my settings.
Solution - Be sure not to remove the iPod nano from the cradle or remove
power to the TuneBase FM while adjusting the TuneBase FM settings. Your
settings are stored in memory when the iPod nano screen returns to the iPod
nano Main Menu.
Issue – The TuneBase FM and iPod nano are in the way of
Fig. B
my car's controls.
Solution - The TuneBase FM has been designed to easily position in a wide
En
range of orientations within the car. Use the flexible gooseneck and the
articulation behind the docking cradle to position it away from any controls
of the car. Be sure to position the gooseneck in as close to an upright position in relation to the
adapter as possible (Fig. B).
Issue - The TuneBase FM connects firmly to the power outlet of my car but the
TuneBase FM still rotates.
Solution - Check to see if the power outlet of your car rotates in its socket. If so, please consult
your car manufacturer.
Issue - The rubber friction washer is out of position and I cannot insert the cigarette-
lighter adapter into the car's power outlet.
Solution - Please use a clean and empty table for disassembly. DO NOT ATTEMPT TO DO THIS IN
THE CAR. Use pliers to loosen the nut at the end of the cigarette-lighter adapter slightly. It is not
necessary to unscrew the entire nut. Move the friction washer back into centered position. Use
pliers to tighten the nut firmly.
Troubleshooting | 09
ea_F8Z063ea.indb 11
15/8/06 12:3
Publicidad
