Publicidad
Idiomas disponibles
Idiomas disponibles
English
Emptying and cleaning the product
Removing the dust bowl and filter (Fig. D, E)
WARNING:
should be cleaned regularly.
1. Press the bowl release button
3
straight off as shown in Fig. D.
2. While holding the dust bowl over a trash can, pull out
8
the filter
to empty the contents as shown in Fig. E.
8
3. Insert cleaned filter
into the dust bowl
4. To replace the dust bowl, push it back onto the handle
until it clicks firmly into place.
WARNING:
without the filters. Optimum dust collection will only
be achieved with a clean filter.
F ig. D
2
Fig. E
8
Cleaning the dust bowl and filter
3
8
The dust bowl
and filter
water.
8
Make sure the filter
and the dust bowl
installing.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
Remove the old filters as described in Cleaning
•
the Filters.
Fit the new filters as described in Cleaning the Filters.
•
(cat. no: HNVCF10)
4
The filter is reusable and
2
and pull the dust bowl
3
.
Never use the appliance
3
3
can be washed in warm soapy
3
are dry before
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
Accessories (Fig. F)
Your hand vac may be supplied with a pet brush tool
furniture and stairs.
To fit the pet brush to the vacuum
1. Insert the pet brush accessory into the front of the dust
3
bowl
as show in Figure F.
2. Make sure the pet brush is fully pushed in.
Fig. F
3
5
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
WARNING:
completely dry before using it.
iMPORTAnT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
TROUBLESHOOTING
If the product does not work, check the following:
•
The charger was correctly plugged in for recharge. (It
feels slightly warm to the touch.)
•
The charger cord is not damaged and is
correctly attached.
•
The charger is plugged into a working electrical outlet.
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service
center nearest you or call the BLACK+DECKER help line at
1–800–544–6986.
ACCESSORIES
Recommended accessories for use with your appliance are
available from your local dealer or authorized service center.
If you need assistance regarding accessories, please call:
1-800-544-6986.
5
for
Make sure the vacuum is
Publicidad
