Publicidad
Idiomas disponibles
Idiomas disponibles
Check the loading status.
Always perform the following final checks before sealing the Case.
・ Has the silica gel been inserted all the way at the specified position?
・ Has the O-ring at the Case opening part been installed properly?
・ Are the O-ring and the O-ring contact surface on the front lid free of dirt
and other foreign matter?
Seal the Case.
When the rear lid is closed (quietly, so that the O-ring will not come out of the
groove), the buckles are engaged with the edge of the rear lid, and the buckle
lock levers are pushed down in arrow direction, the Case will be sealed airtight.
： ・Seal the Case by turning both buckle lock levers down in
CAUTION
arrow direction. When one of the buckles is left open, the
Case will not be sealed and water leakage will be caused.
E-18
Publicidad
