Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
(Continued)
• Save all instructions
INSTALL LOWER HANDLE
1. Orient lower handle with upper square holes as
shown. Align lower handle holes with respective
holes in the frame and loosely install two M10 x
25 mm bolts, lock washers and flat washers on
each side.
2. Using a wrench, tighten bolts securely on
each side.
ATTACH UPPER HANDLE
1. Slide the upper handle down over the lower
handle and align the holes. Orient upper
handle so clutch lever is below handle.
2. Insert the saddle bolts into the holes as shown
and secure with flat washers and handle knobs.
3. Tighten the handle knobs securely.
4. Using one cable tie, secure the control cable to
the handle as shown.
Questions? Call Toll Free at 1-800-737-2112
All manuals and user guides at all-guides.com
(See Figure 5)
Figure 5
(See Figure 6,7)
Figure 6
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
INSTALL THE OUTSIDE TINE SHIELDS
1. Each outside tine shield can be installed on
either side of the main tine shield.
2. Place the outside tine shield underneath the
main tine shield and align the holes.
3. Secure each outside tine shield to the main tine
shield with (3) M6 x 16 bolts washers and
lock nuts.
ENG - 10
Copyright © 2016 MAT Engine Technologies, LLC
(See Figure 8)
Figure 8
Figure 2
Figure 7
Publicidad
