Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
(Continued)
• Save all instructions
B
Assembly Instructions
The tiller comes assembled except for a few parts. The following instructions will help you complete the tiller assembly.
ATTACH THE WHEEL ASSEMBLY
TO THE FRAME
1. Install the wheel assembly to the
frame by removing a hairpin
cotter and flat washer from
one end of pivot rod. Remove
rod. Align pivot holes in wheel
assembly to pivot holes in frame.
Install pivot rod and secure by
reinstalling flat washer and
hairpin. (See Figure 2)
Sharp edge of tine should face down to the ground.
INSTALL THE DRAG BAR
1. Insert the drag bar into the
bottom of the wheel bracket
assembly. (See Figure 4)
2. Insert the pin through the
bracket and the middle
hole of drag bar and secure
with flat washer and
hairpin cotter. (See Figure 4)
Questions? Call Toll Free at 1-800-737-2112
All manuals and user guides at all-guides.com
INSTALL THE TINES
1. Slide the tines onto the tine axle. Install the internal tines
2. For wide 21" tilling, install the outside tines in the way
3. Insert the M8 x 50 bolt with the locknut provided to
Figure 3
ENG - 9
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
(See Figure 3)
first. Sharp edge of the front and top tines should face
down and forward to till the ground. Insert the
M10 x 50 bolt with lock nut provided to secure the
inside tines. Use one flat washer under the head of the
bolt and one under the locknut. Tighten securely.
that the long half of the tine tube faces towards the
inside tines. For narrow 16" tilling, install the outside
tines in a way that the short half tine tube faces towards
the inside tines.
secure the outside tines. Use one flat washer under
the head of the bolt and one under the locknut.
Tighten securely.
Copyright © 2016 MAT Engine Technologies, LLC
Figure 2
Figure 4
Publicidad
