RECIPES
38
7.
When the set time has passed, the appliance will automatically stop operating and
produce 3 beeping sounds. The LCD display will indicate «00:00» and the background
light will blink.
8.
Scoop the ice cream out of the bowl with a plastic spatula and put the ice cream into a
Caution: Never knock the removable bowl or the edge of the bowl onto for instance a
table to remove the ice cream. This will damage the bowl.
Tip: After 60 minutes on the Ice Cream function, it's possible for the ice cream to still be a bit
soft. If you like, however, you can use the Cooling Only function for about 30 minutes to give
the ice cream a stronger consistency. You can of course adjust this to your own preferences.
PROLONGED COOLING
after the end of the mixing process, the appliance will automatically switch to prolonged
cooling. The appliance will cool for another hour in total - with intervals of 10 minutes (cool for
10 min., rest for 10 min.) - to maintain the consistency of the ice cream. After this hour, the ice
cream maker will switch back to its initial start-up status.
ADJUSTING THE TIME DURING THE MIXING PROCESS
When the appliance is operating, you can simply adjust the duration by turning the turning
knob either to the left or to the right.
ADDING TIME AFTER THE MIXING PROCESS
When the mixing process has ended and the appliance has switched back to its initial start-up
status, you can set the time again and press the START/STOP button to mix the ice cream a
little longer. For example because it was not hard enough yet.
When the ice cream becomes too hard, the motor could get blocked. The self-protection
function makes sure that the motor is automatically stopped in that case.
ICE CREAM COLD PREPARATION
· 3 dl milk
· 150g sugar
· 2 dl cream
· 3 egg yolks
· dash of salt
DO9201I
different bowl or container. Do not use metal objects in the bowl to avoid scratching.
When the appliance is not switched off and the ice cream is not removed within 10 minutes
SELF-PROTECTION FUNCTION OF THE MOTOR