Publicidad
Idiomas disponibles
Idiomas disponibles
Wipe the interior of the freezer and replace the electrical plug in the electrical outlet.
Reset the temperature control to the desired setting.
1) If the condense1 is at back of appliance.
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Mains plug is not plugged in or is
loose
Appliance dose not
Fuse has blown or is defective
work
Socket is defective
Appliance
freezes
Temperature is set too cold or the
too much
appliance runs at "7" setting.
Temperature is not properly adjusted.
Door was open for an extended period. Open the door only as long as necessary.
The food is not
A large quantity of warm food was
frozen enough
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Heavy build-up of
frost on the door
Door seal is not air-tight.
seal.
Appliance is not level.
The appliance is touching the wall or
other objects.
Unusual noises
A component, e.g. a pipe, in the side
of the appliance is
touching
appliance or the wall.
if the malfunction shows again contact the Service Center.
These data are necessary to help you quickly and correctly.Write the necessary data here, refer to the
rating plate.
Manual Leaflet
another
part
of
15
Solution
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by
an electrician.
Turn the temperature regulator to a warmer
setting temporarily.
Please look in the initial Temperature Setting
section.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the installation location
section.
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool
setting). At the same
time shape the warmed door seal by hand
such that it sits correctly.
Check the appliance and level it by some
articles.
Move the appliance slightly.
If necessary, carefully bend the component
the
out of the way.
Publicidad
