Descargar Imprimir esta página

Orbegozo EX 5200 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

EX 5200
PREPARATION OF ESPRESSO COFFEE
1.
Remove the filter holder by turning it counterclockwise. Add ground coffee to the filter with the
measuring spoon, one tablespoon of ground coffee is enough to make a cup of coffee. Press the coffee
into the filter well with the flat part of the spoon.
2.
Put the steel mesh into the metal funnel, make sure the funnel tube is aligned with the groove of the
appliance, then insert the funnel into the coffee maker from the "Insert" position, and you can fix it
firmly in the coffee maker by turning it to right until it locks.
3.
Pour the hot water into the mug. After the cup has warmed up, pour the water into the cup and dry the
cup, and then place the cup in the coffee pot again.
4.
At this time, the coffee switch lamp will be on. If it's blinking, wait a moment. Once the lamp stops
flashing, you need to press the coffee button and wait a moment for the coffee to start pouring out.
Press the coffee switch again when you get the required amount and the pump will stop working.
ATTENTION: Do not leave the coffee machine unattended during coffee making, as it will require
manual handling.
5.
When you finish making coffee, turn the filter holder to the left by the handle, remove it from the
coffee machine and pour the ground coffee out of the filter. Use the filter holder tab (on the filter
holder handle) to prevent the filter from falling when emptying the coffee.
6.
Let it cool
ATTENTION: The time required to prepare a cup of coffee is a maximum of 60 seconds. The water pump
will stop working if the preparation exceeds 60 seconds.
WATER HEATER
After preheating, the coffee indicator will stay on. Press it and it will start pumping water. Turn the steam
wheel so that the water begins to flow. To stop press the coffee button again.
MAKE A CAPCHINO OR SPARKLING MILK
You get a cup of cappuccino when you fill an espresso cup with milk foam.
Method:
1. First prepare the coffee with a container large enough as indicated in the part "MAKING ESPRESSO
COFFEE", make sure that the steam wheel is in its initial position.
2. Press the steam button, wait a moment until the steam light stops flashing
3. Fill a jug with about 100 grams of milk to prepare each cappuccino, it is recommended to use whole
milk at refrigerator temperature (not hot!).
Note: for the size of the jug, we recommend that the diameter be no larger than 7cm. For the height, keep
in mind that when you froth the milk, it will double its volume, so choose a jug with a height according to
the milk you are going to froth.
4. Insert the frothing accessory into the jug with the milk (about 2 cm), then turn the spinner to its
maximum position, steam will start to come out of the tube. To froth the milk, move the jug up and
down.
5. When you get the desired foam, stop the skimmer by turning the wheel to its initial position.
15

Publicidad

loading