Descargar Imprimir esta página

Orbegozo EX 5200 Manual De Instrucciones página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

EX 5200
BEFORE THE FIRST USE
To ensure that the first cup of coffee tastes great, you will need to rinse the coffee maker with hot water as
follows:
1. Pour water into the water reservoir within the "MAX" mark on the reservoir. Then replace the water tank
cap.
NOTE: The coffeemaker includes a removable tank for easy cleaning. You can fill the tank first and
then put it in the coffee maker.
2. Place the steel filter in the metal filter holder (no coffee in the steel filter).
3. Place a mug on the removable shelf. Make sure the function switch is in the OFF position
NOTE: The appliance is not equipped with a cup, use your own cup of coffee.
4. Plug the coffee machine into the mains, press the ON / OFF button, the operation indicator light will
come on and the coffee light will start to flash.
5. When the coffee light stops flashing, press the coffee button and it will start pumping water. When the
water starts to come out, close the pump by pressing the coffee button, then press the steam button
and wait a moment. The steam light will begin to flash and the coffeemaker will begin to heat until the
steam indicator stops flashing. Press the coffee button and the water will come out.
6. When the water stops coming out, the process is complete.
NOTE: You may hear a sound when you pump water the first time. This is normal, the coffeemaker is
releasing the air inside. In about 20 seconds the sound will disappear.
PREHEAT
To make a good cup of espresso, we recommend not only heating the coffee machine before making the
coffee, but also heating the filter, the filter holder and the cup, so that the taste of the coffee will not be
influenced by the cold of any of the coffee. This parts.
1.
Remove the water tank, open the lid and fill it with water as far as desired, without exceeding the
maximum level indicated on the tank. Now place the reservoir in the coffee maker.
2.
Place the filter you need (1 cup or 2 cup mono-dose) in the filter holder, to place the filter holder in the
coffee machine the handle must be to the left, push up until it clicks and turn it towards the left. right.
3.
Put a cup.
4.
Connect the coffee maker to the mains.
5.
Press the power button once. The power indicator lights up and the coffee indicator starts flashing.
When finished preheating, the coffee indicator will stay on. Press the coffee switch, when water comes
out, close the pump immediately. The purpose of the step is to pump the water from the tank into the
housing.
6.
When the coffee switch indicator is on, you need to press the coffee switch again, hot water will come
out. When the lamp goes out, close the pump. Preheating is finished.
14

Publicidad

loading