Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
ASSEMBLING YOUR BOWL - LIFT
Pre-Use Cleaning
Before using your stand mixer for
the first time, wash the mixing bowl
and accessories. See the "Care and
Cleaning" section.
Attaching Mixing Bowl
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
1. Make sure the speed control lever
is set to the OFF/0 position.
2. Unplug the stand mixer or
disconnect power.
3. Lower the bowl support by
turning the bowl-lift lever
clockwise.
STAND MIXER
4. Place bowl brackets over the
5. Press down on the back of the
6. Raise the bowl before mixing.
7. Plug into a grounded
Raising and Lowering Mixing Bowl
1. To raise the bowl, turn the
2. The bowl-lift lever will snap
3. To lower the bowl, turn the bowl-
Removing Mixing Bowl
1. Make sure the speed control
2. Unplug the stand mixer or
3. Lower the bowl support by
Lower
4. Grasp the bowl handle
15
15
15
15
locating pins on the bowl support.
bowl until bowl pin snaps into
the spring latch.
3-prong outlet.
bowl-lift lever counterclockwise
as far as possible.
into place when the bowl is
completely raised.
lift lever clockwise.
lever is set to the OFF/0
position.
disconnect power.
turning the bowl-lift lever
clockwise.
and lift the bowl off of the
locating pins.
Continued on next page
Raise
Publicidad
