Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning and maintenance
Make sure to pull out the power plug before the cleaning and maintenance.
Please keep the washer with neat appearance and perform correct
maintenance to prolong the service life of washer.
Cleaning of water inlet hose joint
Unscrew and remove the water inlet hose joint from the washer and clean the
filtering screen of inlet valve with brush.
31
All manuals and user guides at all-guides.com
Identify usual trouble of washer
When the washer is in trouble, please contact local service office or the sales
service department of our company and the customer should not dismantle the
machine without permission.
If the washer can not work normally, or appear abnormity or alarms, please
check and correct asfollows.
FAULTS
INSPECTIONS ITEMS
No water flows in
• If the power is off or the fuse is burned out.
• If the water supply is cut off or the water pressure is too low.
• If the inlet hose is properly connected and the water tap is opened.
• If the filtering screen of inlet valve is blocked by dirt.
• If the coil of inlet valve is damaged. (The slight electromagnetic sound is normal
phenomenon when the inlet valve is switched on)
• If the "Start / Pause" button is pressed after turning on the power.
No washing
• If the power is off or the fuse is burned out.
• If the power supply voltage is too low.
• If the water amount reaches the required water level (The washer will not work if the
water amount does not reach the required water level).
Abnormal
• If the water drain hose is placed very high.
draining
• If the end of water drain hose is blocked.
• If the internal rubber ring of drain valve is blocked by dirt.
Abnormal spin
• If the door lid is closed.
• If all clothing piled largely at one side of barrel or the clothing is excessively placed.
• If the washer is not placed in stable condition or it is placed in inclination state. (The
ground is not flat).
• If the motor belt is loosened.
During the spin process, if washing are piled at one side of the spin barrel, it
will cause unbalance of spin barrel resulting in striking. At this moment, the
controller will feel this unbalance and will automatically correct it (fill in water).
However, if unbalance situation is not removed after continuous three
corrections, which means the computer auto-correction can not resolve the
problem. Then the user has to manually and evenly place the clothing inside
the barrel to solve the problem.
32
Publicidad
