Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of water inlet hose
Fasten one end of the inlet hose to
the tap (there is arubber sealing
washer insider).
Tightly screw another end of water
inlet hose on water inlet valve (with
rubber seal ring inside).
Attention
When tightening the clamping nut, evenly apply the force and do not twist the
water inlet valve to avoid breaking of water inlet valve joint.
31
All manuals and user guides at all-guides.com
Water inlet
hose
Clamping
nut
Preparation before washing
Adjust the adjustable foot making
the washer be placed stable
Extend when clockwise rotating and
shorten when counterclockwise
rotating.
Slightly incline the washer first and
loosen the adjustable foot knob.
Adjust the adjustable foot so as to
ensure four corners of washer be
steadily contacted with the ground.
Then tighten the adjustable foot knob
and lock it. If the ground is obviously
not flat, correction should be made on
the ground surface, otherwise the
washer barrel will incline and knock
the cabinet.
Connect with power source
Open the water tap
32
Publicidad
