Publicidad
Idiomas disponibles
Idiomas disponibles
6. Lid lock button + Pause/start
button
Press Lid lock + Pause/start
button in Operation state, all
switch button invalid, except OFF
button.
Display in the process of program
1. Procedures for display
STANDBY (After the power before
run): Shows each program of some
process lamp and the initial time;
No digital pipe, no showing time.
DELAYSTART (Reservation): After
reservation washing, all the lights
go out, displays reservation time.
If no number on the display no
delay time.
Run: the lights ablaze in the
process of running, long bright if
not running.
If it has a error light long bright; If
the door lock locked, door lock
light long bright.
END LED flashing(light 0.5 S?
drown 0.5 S),at the same time
tweet 6 times (sing 0.5 S-pause
0.5 S), Screen shown in in order of
11, 22, 33, 44, 55, 66, end,
Automatically cut off the power
switch.
37
All manuals and user guides at all-guides.com
2. Alarm display
FAULT
Digital pipe error occurs:
E1: flooding water over
1h,alarm(The door switch effective,
check inlet valve, etc)
E2: Drainage time ≥ w ater level
switch not reset in 6 min．（
The
door switch effective，
check inlet
valve，
etc）
E3: alarming unless the door
closed before spin (close door
switch)
E4: alarming when Bump barrels
three consecutive.(door switch
available)
F8: Water-level sensor fault
(Change water-level sensor)
F6: communication breakdown
(Insert the communication terminal
to dial)
Fd: Electronic locks fault(check
door lock)
Non digital pipe error occurs
E1: both Lock and soak
flashing:(step first and second of
Processes)
E2: both soak and wash flashing:
(step second and third of
Processes)
E3: both wash and rinse flashing:
(step third and fourth of Processes)
E4: both rinse and spin flashing:
(step fourth and fifth of Processes)
F8: both spine and lock flashing:
(step first and fifth of Processes)
F6: Light flashing (communication
breakdown)
Fd: lock flashing (door lock
alarming)
38
Publicidad
