Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Place the appliance carefully into the cutout.
9
CAUTION
– Do not let the glass drop into place. Make sure that
it is supported along a broad area of the edges
when carefully placing the cooktop into the cutout.
– Do not pinch or kink the connecting cable or route
it over sharp edges. If the cooktop is installed over
a built-under oven, route the cable on the rear
corners of the oven to the power outlet. The cable
must be installed such that it does not come into
contact with any hot pars of the cooktop or oven.
5.
Insert the clamping screws into the hold-down
brackets and secure the appliance to the countertop.
Tighten the screws.
NOTICE
Protect delicate countertops by placing a wooden disk
underneath.
6.
Only for flush mount installation:
Note: Make sure that everything is working correctly
before grouting.
Grout the surrounding gap with a suitable
temperature-resistant silicone adhesive. Smooth the
joint seal with a smoothing agent recommended by the
manufacturer. Heed the processing instructions for
the silicone glue. Only start up the appliance after the
silicone glue is completely dry (at least 24 hours,
depending on the room temperature).
NOTICE
Unsuitable silicone adhesive causes permanent
discoloration to natural stone countertops.
Connect Electrical Supply
Refer to data plate for more information. See "Service"
for data plate location.
The maximum current raing of the branch-circuit breaker,
the wire sizes and the connections must be conform to
the requirements of the National Electrical Code or
Canadian Electrical Code and all local codes and
ordinances.
Attach flexible conduit to the junction box. Connect the
lead wires to the junction box supply wires in proper
phase:
black (L1) to black
▯
red (L2) to red
▯
green or bare to ground
▯
Check the Installation
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Remove everything from the cooktop surface. Clean
cooktop surface with cooktop cleaning creme.
Switch on the circuit breaker.
Verify that elements function properly.
Installation Procedure
en-us
11
Publicidad
