Garland FUM 312 ML Manual De Instrucciones página 30

English
ON
Pump regulated between 0% and 100%: If you prefer
to regulate the intensity of the pump, turn on the
machine directly by turning the potentiometer.
6.6.2. STOP
Set the On / Off switch to the "O" position and the
potentiometer to the minimum.
6.7. LOW BATTERY LOAD INDICATOR
When the battery of your fumigator has little charge,
the output power of the liquid will be less, and you will
have to charge the battery.
6.8. VERIFICATION POINTS AFTER START-UP
It is important to pay attention to possible loose parts
and temperature of the machine. If you detect any
anomaly in the machine, stop immediately and check
it carefully. In case of any anomaly or problem take
the machine to the technical service to repair it. In no
case continue using the machine if the operation does
not seem appropriate.
Do not use the machine if it is damaged or
improperly regulated.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this machine for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
7.1. PREPARING THE LIQUID TO BE SPRAYED
Prepare the product mix to be sprayed in a tank
in which you can insert the suction hose with the
filter and the return hose. Always follow the product
manufacturer's instructions and safety standards.
7.2. WORK WITH THE MACHINE
1. Put the switch to "I"
2. Use the regulator to adjusting de speed
3. Start spraying the product in the desired area by
squeezing the trigger.
7.3. VOLTMETER
The voltmeter on the machine will indicate the current
battery voltage.
L
Low voltage
N
Normal voltage
F
High voltage
7.4. COMPLETION OF SPRAYING
After using the machine it is necessary to clean the
circuit using clean water. When you stop using the
machine:
1. Turn off the machine by moving the switch to the
"O" position.
30/92