Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure the following are contained in the purchased product pack:
• high-pressure cleaner;
• high-pressure delivery hose with quick coupling;
• spray gun;
• lance hose;
• suction connection kit;
• external detergent suction hose kit;
• instruction manual - safety precautions;
• instruction manual - operation and maintenance;
• warranty certificate;
• after-sales centre booklet;
• EC declaration of conformity;
• nozzle cleaning pin.
In case of problems, contact your dealer or an authorised after-sales centre.
The standard fittings of the high-pressure cleaner can be integrated with the following range of accessories:
•
type water mains disconnector: mandatory for connecting up to the drinking water mains.
BA
• sandblasting lance: designed to clean surfaces, eliminating rust, paint, scale, etc.;
• drain cleaning kit: designed to unblock pipes and ducts;
• rotating-nozzle lance: designed to remove resistant dirt;
• foam lance: designed for more effective detergent distribution;
• lances and nozzles of various types.
• Connect the quick coupling (15) of the hose (14) to the water outlet connection (7), screw down and secure.
Operation E in fig. 6.
• Screw up the connection (13) of the high-pressure hose to the thread of the spray gun (9) and tighten well
using two 22 mm fixed wrenches (not supplied). Operation D in fig. 6.
• Fit the filter (21) in the water inlet connection (20). Fit the seal (22) in the water inlet quick-fit connection (23)
and screw up to the connection (20). Operation A in fig. 2.
• Move the high-pressure cleaner to work position.
• Completely unwind the high-pressure hose (14).
• Attach a supply pipe to the water inlet's quick connection (23) using a normal garden connector. Operation F
in fig. 6.
• Open the water supply tap and make sure this is not dripping;
- if the connection is made to the drinking water mains, a
used, in conformity with EN 12729 standard, and available from your dealer (fig. 5). With regard to its use,
refer to the relative instruction manual;
- in case of supply from a water tank, introduce the suction hose inside the tank and make sure the vertical
distance between the water level and the pump is no more than 1.5 m (4.9 ft). Operation G in fig. 5.
• Make sure the master switch (1) is on "0" position and insert the plug. Operation C in fig. 6.
• Move the master switch (1) to position "1".
• Press the spray gun lever (19) and wait for a continuous jet of water to come out;
• Move the master switch (1) to "0" position and connect the lance hose (10) to the spray gun (9), tightening
well. operation B in fig. 6.
STANDARD FITTINGS
OPTIONAL ACCESSORIES
INSTALLATION - FITTING ACCESSORIES
OPERATION - PRELIMINARY ACTIVITIES
type water mains disconnector (26) must be
BA
EN
17
Publicidad
