Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
The activated charcoal filters are not included in the delivery.
■
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Trouble shooting
Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Malfunction table
Problem
Possible cause Solution
The appliance
The plug is not
does not work
plugged in.
Power cut
Faulty fuse
The button illu-
The control unit
mination does
is faulty.
not work.
The lighting
The bulbs are
does not work.
faulty.
--------
14
Connect the appliance to
the electricity supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse for
the appliance is OK
Call the aftersales service.
For information on chang-
ing the bulbs, see the
"Replacing Bulbs" section.
Remove metal grease filter: See above.
1.
Turn the old activated charcoal filter and pull away from the
2.
bracket.
¨
Push the new activated charcoal filter onto the bracket and
3.
turn.
©
Fit the metal grease filter: See above.
4.
Replacing bulbs
:
Risk of electric shock!
When changing the bulbs, the bulb socket contacts are live.
Before changing the bulb, unplug the appliance from the mains
or switch off the circuit breaker in the fuse box.
Important Only use a bulb of the same type and same power
(see also the bulb holder or rating plate).
Replacing halogen bulbs
Note: When inserting halogen bulbs, do not touch the glass
tube. Use a clean cloth to insert the halogen bulbs.
Carefully remove the bulb ring using a suitable tool.
1.
Pull out the bulb and replace it with a bulb of the same type.
2.
Insert the bulb cover.
3.
Insert the mains plug or switch on the fuse again.
4.
Replace the bulb with one of the same type:
Voltage: 12 V
Power: max. 20 W
Socket: G4
Publicidad
