1
Press (SOUND) momentarily until "LP1"
appears.
L P 1
SUR EQ
ALL
2
Rotate the dial to select the desired
listening position.
The listening positions appear in the order
shown above.
After three seconds, the display goes back
to the normal playback mode.
Adjusting the listening position
1
Press (SOUND) for two seconds.
2
Rotate the dial to select the desired
listening position.
3
Press (4) (n).
L P 1
SUR EQ
L
4
Rotate the dial to adjust the centre of
the sound field to the left or right. Then
set the centre of the sound field.
Centre moves to the L (left)
Centre moves to the R (right)
5
Press (4) (n).
L P 1
SUR EQ
R
6
Rotate the dial to adjust the centre of
the sound field to the front or rear.
Centre moves to the R (rear)
Centre moves to the F (front)
7
Press (SOUND) for two seconds.
When the effect setting is complete, the
normal playback mode display appears.
Adjusting the fader (FAD)
Normally, with the DSP mode on, the volume
of the output sound from the rear speakers is
lowered automatically to improve the
efficiency of the listening position setting. If
you want to raise the rear speaker volume,
adjust the fader.
1
2
3
R
Adjusting the volume of
the subwoofer(s)
1
2
F
3
Follow steps 1 to 3 of "Selecting a
surround menu" (page 21).
Press (SOUND) momentarily until "FAD"
appears.
Rotate the dial to adjust the fader.
Decreases the front speaker
volume
Increases front speaker volume
After three seconds, the display goes back
to the normal playback mode.
Press (SOURCE) to select a source (radio,
tape, CD, or MD).
Press (SOUND) repeatedly until "SUB"
appears.
Rotate the dial to adjust the volume.
After three seconds, the display goes back
to the normal playback mode.
EN
23