Fiorenzato F64E XGi Manual Del Usuario página 24

MAINTENANCE
It is essential to periodically check the state
of the supply cable and plug . In the event
the supply cable or plug are damaged, call in
skilled technical personnel to replace them,
in order to prevent any risk . In CE-certified
appliances a special tool is required to open
the base plate to access the cable . We recom-
mend using original spare parts only . In order
to assure the lasting efficiency of the appli-
ance, skilled technical personnel must be
called in to perform periodical maintenance,
including detailed checks of the state of those
components subject to wear . The state of the
grinding blades must be checked periodically .
Keeping the grinding blades in an excellent
state assures high-quality grinding, resulting
in greater productivity and limited overheat-
ing .
CLEANING THE APPLIANCE
Disconnect the power supply from the
grinder-doser by unplugging it before clean-
ing . The appliance must not be cleaned using
water jets . Do not install the grinder-doser in
rooms where water jets are used for clean-
ing . The grinder-doser must be cleaned
periodically by skilled technical personnel
only . Use perfectly clean, disinfected cloths
or brushes for cleaning . Do not use abrasive
products as these are liable to take the sheen
off shiny parts .
Hopper
Wash the hopper once it has been removed
from the appliance (unscrewing the relevant
fastening screw), using neutral soap and wa-
ter, rinse abundantly with lukewarm water
and dry thoroughly . It is advisable to clean
the hopper periodically . Once the hopper has
been cleaned, it must be attached to the up-
per grinding blade holder using the relevant
screw .
Grinding system
Remove the safety screw which prevents the
adjustment disk from being removed . Unscrew
the adjustment disk by turning it clockwise .
Having removed the upper grinding blade
holder, clean the grinding blades, the threads
and the entire grinding system thoroughly us-
ing a clean brush and cloth . Having refitted the
upper grinding blade holder in the relevant
slot, screw the adjustment disk back on, and
after refitting and securing the hopper adjust
the grinding as required .
Fig . A
This information is addressed only to the own-
ers of appliances bearing the symbol (Fig . A)
on the adhesive label with the technical data
applied to the product (serial number label):
This symbol means that, according to the cur-
rent regulations, this is an electrical or elec-
tronic unit and complies with EU Directive
2002/96/EC (RAEE) . Therefore, at the end of
its life, it must be disposed of separately from
domestic waste, by delivering it free of charge
to a recycling centre for electrical and electron-
ic appliances, or by returning it to the retailer
when you purchase a similar unit . The user is
responsible for delivering the unit, at the end
of its life, to the appropriate recycling centre
otherwise he/she will incur the penalties pro-
vided for by the waste regulations in force at
the time . The recycling centre will then decide
whether the unit has to be recycled, treated
or disposed of in an environmentally friendly
manner, limiting its effect on the environment
and public health . For more detailed informa-
tion regarding available recycling centres, con-
tact your local waste department or the store
where the unit was purchased . Manufacturers
and importers comply with their responsibility
for the recycling, treatment or disposal both
directly or by taking part in a collective system .
24
DIRECTIVE
2002/96EC
(RAEE):
INFORMATION
FOR USERS