Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Cleaning
CLEANING
The dual-drawer refrigerator defrosts automatically. The
water on back wall drains into the water tank and is
evaporated by the condenser.
IMPORTANT: Do not use harsh chemicals, ammonia,
chlorine bleach, concentrated detergent, solvents,
abrasives or metal scouring pads to clean your product
inside or out. They can damage and/or discolor the
finish.
WARNING
Unplug your appliance or disconnect power before
cleaning.
Failure to do so can result in death, electric shock or
personal injury.
General
2. Wash interior surfaces, accessories, and outer frame
with a solution of warm water mixed with 3 - 4
tablespoons of baking soda.
NOTE: Before using cleaning products, always read and
follow manufacturer's instructions and warnings to avoid
personal injury or product damage.
3. Rinse with clean, warm water.
4. Dry thoroughly with a soft cloth.
5. Plug in or reconnect power.
6. Clean the drain hole using a small, soft material such
as a cotton swab. To access the drain hole, you must
first remove the lower drawer.
To remove the lower drawer:
1. Slide out the lower drawer completely.
the lower drawer to the drawer glides.
Location of screws
3. Remove the lower drawer.
4. Clean the drain hole illustrated
below with a soft material such
as cotton swab, then install the
lower drawer according to the
8
ELECTRICAL SHOCK
HAZARD
reverse procedure as above.
Door Gaskets
Gaskets must be kept clean and pliable to ensure a
proper seal.
baking soda and warm water.
will keep the gasket pliable and ensure a good seal.
VACATION AND MOVING
Vacation
If you will be away for an extended period of time and do
not want to leave the appliance on while you are gone,
prepare it for your absence.
1. Remove all items.
2. Press and hold POWER on the control panel for 3
seconds to turn off cooling.
6. Prop drawers open, so air can circulate inside.
Moving
If you are moving your dual-drawer refrigerator to a new
home, prepare the appliance for the move.
IMPORTANT:
damaging the refrigerant tubing or increasing the risk
of a leak.
a 45° angle. This could damage the compressor and
the sealed system.
1. Complete vacation preparation steps 1 through 5. See
2. Take out all removable parts, wrap them well, and
tape them together so they don't shift and rattle during
the move.
3. Tape the drawers closed and tape the power cord to
the back of the refrigerator.
Location
of drain
hole
49-1000129 Rev. 0
Publicidad
