Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
Questions? Visit our Website at: cafeappliances.com
In Canada, visit cafeappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
—
and ordinances. Save these instructions for local
inspector's use.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer –
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
can vary
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install dual-
drawer refrigerator.
Failure to do so can result in back or other injury.
WARNING
CUT HAZARD
Cabinet edges along stamp/cut-out areas may
be sharp. Avoid placing hands, fingers or other
appendages near these areas.
Failure to do so can result in cuts.
IMPORTANT: Handle with care when moving dual-
drawer refrigerator to avoid either damaging the
refrigerant tubing or increasing the risk of a leak.
IMPORTANT: When moving the dual-drawer refrigerator,
never tilt it more than a 45° angle. This could damage the
compressor and the sealed system. If the dual-drawer
any period of time, wait one hour before plugging in the
refrigerator to allow the refrigerant to settle.
49-1000129 Rev. 0
Observe all governing codes
Dual-Drawer Refrigerator
LOCATION REQUIREMENTS
IMPORTANT: This dual-drawer refrigerator is
designed for built-in use only. Before use, this
dual-drawer refrigerator must be installed properly.
NOTE: Allow the dual drawer to sit upright on its
base for at least one hour before installation.
• Do not install the dual-drawer refrigerator where
the temperature will go below 55°F (13°C) because
it will not run often enough to maintain proper
temperatures.
• Do not install the dual-drawer refrigerator where the
temperature will go above 110°F (43°C) because it
will not perform properly.
• Install it on a floor strong enough to support it fully
loaded.
• Do not install the dual-drawer refrigerator in a
location exposed to water (rain, etc.) or direct
sunlight.
TOOLS NEEDED
• Phillips Screwdriver
• Measuring Tape
• Carpenter's Level
PARTS SUPPLIED
• Anti-tip Brackets
• Screws
• 1/8 Allen Wrench
9
Publicidad
