Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
5. Speed Selector
The impact wrench has a speed selector (E) located on
the base to select among three different variable-speed
ranges (refer to specifications).
1. The impact wrench provides lowest speed and
torque.
2. The impact wrench provides medium speed and
torque.
3. The impact wrench provides maximum speed and
torque.
NOTICE: Do not change speed range while the tool
is running. The speed range will not change until you
release the variable-speed trigger switch.
6. Finish Mode
The finish mode permits better control of the impact
driving action and is useful as the head of the fastener
approaches the level of the workpiece. In finish mode,
each successive depression of the variable-speed trigger
switch (D) will result in a very short impacting burst. The
finish button (E) is located on the base of the tool.
a. To engage the finish mode, ensure a battery is
correctly attached to the tool, depress and release
the variable-speed trigger switch to turn on the tool,
then press the finish button. The green light on the
finish button will illuminate to indicate that the finish
mode is activated.
b. The finish mode can be turned on and off for
approximately 15 minutes after the last variable-speed trigger release.
c. If more than 15 minutes have passed, repeat the process described above to engage the finish
mode.
5
E
6
F
10
kobalttools.com
Publicidad
