Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610007873 12-09:BM 2610007873 12-09 12/17/09 7:31 AM Page 8
INTENDED USE
This tool is intended for the fastening and
loosening of bolts, nuts and various threaded
fasteners. This tool is not intended for use as
a drill.
The Bosch model PS41 Cordless Impact
Driver has a collet that accepts only
standard 1/4" hexagonal shank accessories
with power groove. The low RPM capability
of this model is not a deficiency. On the
contrary, low speed means high torque and
high torque is a definite plus for efficient drilling
and driving. The low speed also provides more
control to prevent stripout of the screw and
damage to the work surface.
INSERTING AND REMOVING
ACCESSORIES
To avoid loss of control,
W RNING
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
Your tool is equipped with a quick release
chuck. To insert an accessory, simply pull
locking sleeve forward, insert desired
accessory into chuck and release locking
sleeve (Fig. 2).
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
W RNING
"OFF" position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 3). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
Operating Instructions
BRAKE
To remove an accessory, pull locking sleeve
forward and simply remove it from the chuck.
FIG. 2
SCREWDRIVER
BIT
Do not use this tool as a drill. Tools equipped
with shut-off clutches are not designed for
drilling applications. The clutch can shut off
automatically and without warning. Attempting
to restart drilling after shut-off has been
reached can cause the tool to twist out of your
hand until the clutch again reaches shut-off. Do
not attempt to insert quick-change type drill bits
into this chuck.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left .
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
FIG. 3
Do not change direction of
C UTION
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
-8-
LOCKING
SLEEVE
CHUCK
BIT
HOLDER
Publicidad
