BM 2610007873 12-09:BM 2610007873 12-09 12/17/09 7:31 AM Page 9
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when drilling/driving (Fig. 1).
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition
indicator lights (Fig. 1). The indicator lights
shows the charge condition of the battery for a
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing on
both sides of the battery release tabs and pull
downward (Fig. 4).
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
If battery release tabs are
W RNING
cracked
damaged, do not insert into tool. Battery can
fall out during operation.
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced.
3. Remember to unplug charger during
storage period.
4. If battery does not charge properly:
CHARGER INDICATORS, SYMBOLS AND MEANING (Model BC430)
If the indicator lights are "OFF", the charger
is not receiving power from power supply outlet.
If the green indicator light is
"ON", the charger is plugged in
but the battery pack is not
inserted, or the battery pack is fully charged
and is being trickle charged.
few second when the On/Off trigger is pressed
halfway or fully.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
or
otherwise
IMPORTANT CHARGING NOTES
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when lights
are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and charger to
your local Bosch Service Center. See "Tools,
Electric" in the Yellow Pages for names and
addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
charging will automatically stop when the
battery pack is fully charged.
-9-
Capacity
reserve
B TTERY
RELE SE
T BS
If the green indicator light is
"BLINKING", the battery pack is
being fast-charged. Fast-
> 2/3
> 1/3
< 1/3
FIG. 4