Maintenance
Clean detergent drawer
■
The structure of detergent case varies from different machine models;
please follow steps and methods shown in below figure to clean the
detergent case:
Auto dispenser
If there is detergent or softener residue in the case:
■
♦ As fig. a(c) shows, pull the case and press down the limit rod; pull the
whole drawer out;
♦ As fig. b(d) shows, open the case (pick it up slowly)and take out syphon
plate(lift it up);
♦ Use tap water or brush to wash detergent case and syphon pipe;
♦ Restore case cover and syphon pipe, and push the drawer in.
■
A little detergent will flow into water box when drawing the case, this is
normal.
Try not repeatedly opening and closing the case of detergent loss;
Pay attention to the spillover of detergent that may cause inconvenience
■
when adjusting (like tilting and moving, etc.) the machine (draw out the
case before adjusting).
Recovery from freezing
■
The washing machine may freeze when it drops below 0
1.Turn off the washing machine, and unplug the power cord.
2.Pour warm water over the water tap to loosen the water hose.
3.Disconnect the water hose, and soak it in warm water.
4.Pour warm water into the drum and leave it for about 10 minutes.
5.Reconnect the water hose to the water tap.
tAiN• n -
1.When the washing machine is reused, make sure the ambient
temperature is above 0
2.lf your washing machine is located in the room where it can get frozen
easily, please drain the remaining water inside drain hose and inlet hose
thoroughly.
3.Please contact a technician if your washer is frozen.
°
C.
22
Common dispenser
°
C.
V.1