Safety Label; Technical Characteristics; Unpacking; Machine Preparation - Tennant 3610 Manual Del Operador

- Use manufacturer supplied or approved
replacement parts.
- All repairs must be performed by a qualified
service person.
- Do not modify the machine from its original
design.
6. When transporting machine:
- Turn machine off.
- Get assistance when lifting machine.
- Use a recommended ramp when loading/
unloading into/off truck or trailer.
- Use tie-down straps to secure machine to
truck or trailer.

SAFETY LABEL:

The safety label appears on the machine in the location
indicated. Replace label if it is missing or if it becomes
damaged or illegible.
SAFETY LABEL - Located on MACHINE
COVER.

TECHNICAL CHARACTERISTICS:

Description
Width-including side brush
Length-including side brush
Height-including handle
Machine height W/Handle folded
Maximum sweeping width
Weight
Hopper capacity (real)
Run time
Filtering surface
Productivity Rate-Theoretical
Productivity Rate-Estimat\Actual
Total power consumption
Type of battery
Noise level
600mm 23,75"
730mm 28,75"
950mm 37,5"
559mm
650mm
53Kg 115lbs
9,3 Lt 1,25 Cu.ft
2h
0,95mq 10 sq.ft
1800mq/h 18000 sq.ft
900 mq/h 9000 sq.ft
360W/18A 360W/18A
Sealed maintenance free 42A/5h
61dba
Home Find... Go To..

UNPACKING:

Unpack the machine carefully avoiding movements that
can cause damage.
Once the machine is unpacked, check the condition of its
parts. In case the machine is broken in any of its parts,
contact immediately our authorized dealer.
For shipping and packaging purposes, some assembly is
required. For correct assembling instructions, see

machine preparation

Packaging contents:
Machine
Side brush
Use and maintenance manual
Maintenance free type battery
4mm hex wrench
20 amp spare fuse
Charger cord
In the case anything of the above should be missing,
contact immediately our authorized dealer.
Assure that all packaging material (plastics, carton,
pallet, etc.) are collected and stored away from children.
MACHINE PREPARATION:
Side brush assembly:
-Raise the front part of the machine, slide the brush on to
the shaft until it locks into place .
22"
25"
3