RedMax BCZ3001S Manual De Instrucciones página 20

SE1
(1)
[BCZ3001SW]
[BCZ3001SW-CA]
SE2
(1)
SE3
[BCZ3001S]
[BCZ3001S-CA]
SE4
SE5
20
[BCZ3001S]
[BCZ3001S-CA]
(2)
(1)
[BCZ3001SW]
[BCZ3001SW-CA]
English
6. Set up
IMPORTANT
Tighten the screws gradually by turns.
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you. (SE1)
(1) About 19 inches (48cm)
(2) About 14.5 inches (37cm)
■ HIP PAD
• Fix the tube by the band. (SE2)
(1) Band
■ INSTALLING CUTTING ATTACHMENT GUARD
• Put the cutting attachment guard on the braket,
attach it with the 2 screws. (SE3)
IMPORTANT
2 kinds of cutting attachment guard are packed in with
BCZ3001SW/BCZ3001SW-CA. Choose the guard
suitable for a line head. If the right guard is not used, it
may lead to a serious accident. (SE3)
(1) Guard for Line Head (Red) : (T3245-24110)
(2) Guard for Blade (Black) : (T3246-24110)
■ INSTALLING LINE HEAD (SE4)
1. While locking the gear shaft, by inserting the
supplied tool into the upper holder on the gear box,
loosen and remove the hexagon nut(left-handed)
2. Fit the line head assembly to the gear shaft over the
holders. Hand-tighten it securely.
IMPORTANT
You need not holder (B) and nut when installing the
line head.
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head
just touching on the ground. (SE5)