Publicidad
Idiomas disponibles
Idiomas disponibles
CP FL 0022, CP FL 0022 S
6. Insert the shank into the cylinder and screw the
tool retainer onto the cylinder until it is locked
into position by the retaining lock ring.
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
Start and stop
Start the machine by squeezing the trigger while
firmly holding the handle.
Stop the machine by releasing the trigger. The
trigger returns automatically to the stop position.
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring in such a way that the machine is
♦
capable of breaking the material without levering.
9800 0836 90a | Original instructions
Safety and operating instructions
♦
Never try to break off too large pieces. Adjust the
breaking so that the inserted tool does not get
stuck.
Breaking
Let the machine do the work; do not press too
♦
hard.
Avoid working in extremely hard materials for
♦
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
Operating without insertion tool or operating
♦
with an uplifted machine must be avoided.
Idling should be avoided as far as possible.
♦
♦
When the machine is lifted, the start and stop
device must not be activated.
♦
Check regularly that the machine is well
lubricated.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
Maintenance
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
Before starting maintenance on the machine,
♦
clean it in order to avoid exposure to hazard
substances. See "Dust and fume hazards"
♦
Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
♦
When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦
For major service to the machine, contact your
nearest authorised workshop.
15
Publicidad
