Publicidad
Idiomas disponibles
Idiomas disponibles
Caution! To reduce the risk of injury or property
damage:
f Pull cord by plug rather than cord when disconnecting
the AC Charging Adapter from the unit.
f Never attempt to jump-start or charge a frozen battery.
f To recharge this unit, use only the supplied AC or DC
Charging Adapter.
f Vehicles that have on-board computerized systems
may be damaged if vehicle battery is jump-started.
Before jump-starting, read the vehicle's owner's manual
to confirm that external-starting assistance is suitable.
f When working with lead acid batteries, always make
sure immediate assistance is available in case of
accident or emergency.
f Always have protective eyewear when using this
product: contact with battery acid may cause blindness
and/or severe burns. Be aware of first aid procedures
in case of accidental contact with battery acid.
f Have plenty of fresh water and soap nearby in case
battery acid contacts skin.
f If battery acid contacts skin or clothing, wash
immediately with soap and water for at least 10
minutes and get medical attention immediately.
f Never smoke or allow a spark or flame in vicinity of
vehicle battery, engine or power station.
f Remove personal metal items such as rings,
bracelets, necklaces and watches when working with
a lead acid battery. A lead acid battery can produce a
short circuit current high enough to weld a ring, or
similar metal object, to skin, causing a severe burn.
f Do not wear vinyl clothing when jump-starting a
vehicle when jump-starting a vehicle, friction can
cause dangerous static-electrical sparks.
f Jump-start procedures should only be performed in a
safe, dry, well-ventilated area.
f Always store battery clamps when not in use. Never
touch battery clamps together. This can cause
dangerous sparks, power arcing and/or explosion.
f When using this unit close to the vehicle's battery and
engine, stand the unit on a flat, stable surface, and
be sure to keep all clamps, cords, clothing and body
parts away from moving vehicle parts.
f Never allow Red and Black clamps to touch each
other or another common metal conductor — this
could cause damage to the unit and/or create a
sparking/explosion hazard.
a. For negative-grounded systems, connect
the Positive (Red) clamp to the Positive
ungrounded battery post and the Negative (Black)
clamp to the vehicle chassis or engine block
away from the battery. Do not connect the clamp
to the carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal part of the
frame or engine block.
All manuals and user guides at all-guides.com
f If the connections to the battery's Positive and Negative
f Always disconnect the Negative (Black) jumper cable
f Do not expose battery to fire or intense heat since
f Place this unit as far away from the battery as DC
f Never allow battery acid to come in contact with this unit.
f Do not operate this unit in a closed area or restrict ventilation
Skin: If battery acid comes in contact with skin, rinse immediately
with water, then wash thoroughly with soap and water. If redness,
pain, or irritation occurs, seek immediate medical attention.
Eyes: If battery acid comes in contact with eyes, flush
eyes immediately, for a minimum of 15 minutes and seek
immediate medical attention.
f Important: This unit is delivered in a partially charged
f All ON/OFF switches should be in the OFF position
f Never insert anything other than the supplied
f Do not use any accessory that is not recommended or
f Do not use this unit to operate appliances that
f This system is designed to be used only on vehicles
ENGLISH • 29
b. For positive-grounded systems, connect
the Negative (Black) clamp to the Negative
ungrounded battery post and the Positive
(Red) clamp to the vehicle chassis or engine block
away from the battery. Do not connect the clamp
to the carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal part
of the frame or engine block.
terminals are incorrect, the reverse polarity indicator
will light (red) and the unit will sound a beep. Disconnect
clamps and reconnect to battery with correct polarity.
first, followed by the Positive (Red) jumper cable,
except for positive grounded systems.
it may explode. Before disposing of the battery, protect
exposed terminals with heavy-duty electrical tape to
prevent shorting (shorting can result in injury or fire).
cables permit.
in any way.
Warning! First Aid:
state. Fully charge unit with a household extension
chord (not supplied) for a full 48 hours before using for
the first time. You cannot overcharge the unit using
the AC charging method.
when the unit is charging or not in use. Make sure all
switches are in the OFF position before connection to
a power source or load.
recommended appliance power/recharging cords into
the 12V DC power outlet on this unit.
provided by the manufacturer.
need more than 5 amps to operate from the 12V DC
accessory outlet.
with a 12V DC battery system. Do not connect to a 6V
or 24V battery system.
Publicidad
