Publicidad
Idiomas disponibles
Idiomas disponibles
AP 7007
VACUUM CLEANER FILTERS
Motor protection filter
Motor protection filter cleans the air that is sucked in before it enters into motor. The air is cleaned of fine
dust, mites, bacteria and viruses. This prevents dirt or dust particles from getting into the motor or the
surrounding air.
Cleaning the exhaust air filter
The exhaust air filter cleans the air at the end before it leaves the
vacuum cleaner. You can clean this exhaust filter following below
instructions:
1. Turn off and unplug the vacuum cleaner. Remember pull on the plug
and not on the cord.
2. Open the exhaust air grill (this grill is on top side of vacuum cleaner).
3. When you open the grill, air filter will be visible.
4. Rinse the filter with cold water for a moment and after allow to dry.
Caution!
1. Always clean the filter with clear water and don't use soap or detergent. It would damage the filter.
2. Clean filter with clear water and dry it naturally. Do not dry with heat, it could deform.
CARE AND MAINTENANCE
Cleaning of vacuum cleaner
To clean the housing of device, disconnect and unplug it.
Danger! Never expose the vacuum cleaner to the effects of weather (rain, wind, etc.). No parts may be
washed by dish washer.
The housing, inner tank and rear outlet can be wiped with a damp cloth, always taking care that no liquids
get inside vacuum cleaner. Do not use strong products to clean the device because it could corrode the
plastic surface. Before to plug again vacuum cleaner ensure that all parts are thoroughly dry.
Hair and fluff may gather on the running wheels and on the floor nozzle of the vacuum cleaner in time. You
should remove there to ensure that handling of the vacuum cleaner is always easy.
Note: we do not recommend using lubricant or oil on wheels because it will cause dirt and fluff to
stick even better.
15
Publicidad
