Making Hot Water; Specific Functions Of The Pid Model - Ascaso Steel Manual Del Usuario

Step 1 (texturing) has not been
performed properly and the air
has not been allowed to work the
milk.
5.

Making hot water

UNO model
1. Put a cup below the steam nozzle
.
5
2. Turn the hot water/steam knob
and press the switch
light will come on
the reverse operation to obtain the
required water.
Remember: do not heat the milk to
over 75°C. Beyond this temperature
you will scald the milk and it will not
be suitable for cappuccino.
The espresso is released at 75-80°C.
The milk is textured and heated to
between 55-70°C. It is important
to maintain these temperatures for
serving. The cups should therefore
be warmed on the cup warmer. If this
is not possible, heat the cup with hot
water prior to use.
DUO/TRIO models
1. Put a cup below the hot water
nozzle 16 .
2. Press the switch
light will turn on
reverse operation to obtain the
required water.
6.
Specific functions of the
PID model
The UNO PID and DUO PID models
have a control system consisting of
a screen(24) and two control buttons
25 26
1. Coffee temperature, shown on
screen. To change it, press the
button , the screen will display
25
the message PrG, indicating that
it is in temperature programming
mode. Press button
4
(the pilot
14
. Carry out
23
14 , the pilot
. Carry out the
23
to reduce
25
the temperature, press
increase it. After three seconds
without pressing a button, the
system will return to its initial
setting.
2. Temperature units, in °C or F.
3. Pre-infusion, selecting a pump
activation time during the process,
from 0 (off) to 5 seconds.
4. Timer, showing the time taken
to make a coffee. This function
can be turned on or off in the
programming menu. If on,
the screen shows the time
24
taken to make a coffee, not the
temperature.
5. In stand-by mode, selecting an
activation period from 0 (off),
0.5/1/2 hours.
6. Correction parameter between
water temperature and
measurement in the machine. This
enables the water temperature to
be adjusted according to room
temperature.
7. In DUO PID models the steam
system can be turned on and off.
Enter the programming menu to
change the values of parameters 2 to
7. The process is as follows:
1. With the machine on, press and
hold button while pressing
26
for 3 seconds. The screen
25
will show the words SET UP
24
alternately, indicating that the
programming menu has been
accessed.
2. Press button
25
the different parameters that can
be modified. Once the required
parameter is reached, press
button to change its values.
26
3. To change the value of the
selected parameter, press buttons
and to reduce or increase
25 26
the values, respectively.
4. After three seconds without
pressing a button, the system
saves the data and returns to its
initial setting.
ascaso
to
26
to scroll through
33