Bosch GKS Professional 65 CE Manual Original página 22

OBJ_BUCH-359-002.book Page 22 Monday, May 11, 2009 9:50 AM
22 | English
Use suitable detectors to determine if utili-
ty lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Do not operate the power tool stationary. It
is not designed for operation with a saw ta-
ble.
Do not use high speed steel (HSS) saw
blades. Such saw blades can easily break.
Do not saw ferrous metals. Red hot chips
can ignite the dust extraction.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
1 609 929 K95 | (11.5.09)
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
GKS 65:
The machine is intended for lengthways and
crossways cutting of wood with straight cutting
lines as well as mitre cuts in wood while resting
firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g.,
profiles, can also be sawed.
Working ferrous metals is not permitted.
GKS 65 CE:
The machine is intended for lengthways and
crossways cutting of wood with straight cutting
lines as well as mitre cuts in wood while resting
firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g.,
profiles, light uilding materials and plastic can
also be sawed.
Working ferrous metals is not permitted.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 On/Off switch
2 Lock-off button for On/Off switch
3 Thumbwheel for speed preselection
(GKS 65 CE)
4 Auxiliary handle
5 Spindle lock button
6 Scale for mitre angle
7 Wing bolt for parallel guide
8 Clamping lever for bevel-angle preselection
9 Cutting mark, 45°
10 Cutting mark, 0°
Bosch Power Tools