Moen ET900 Guia De Instalacion página 15

Anchors
Docking Station
REMOTE CONTROL COMPONENTS
1
2
3
Mounting Bracket
Screws
Remote Control
Determine your desired location for the remote control and its holder. The
holder should be close enough for the user to reach while seated. Hold the
bracket up to the wall and mark the screw holes with a pencil. Make sure
the remote control holder is level on the wall.
Drill marked holes using a 3/16" drill bit. Tap in anchors (G - Items List)
using a hammer. See diagram above for correct install process.
Secure Docking Station to the wall using the supplied screws (G - Items
List). Prior to installing the remote control, install 2 AAA Batteries
(B - Items List) into the remote controler and then place the remote onto
the holder. Installation of Remote Control is complete.
INSTALLING THE
REMOTE CONTROL
When the product leaves the factory, the remote
control and the product are connected. If the
remote control and product are not connected;
please review our troubleshooting section.
INS12982- 06/23