Moen ET900 Guia De Instalacion página 8

1 2
4-5/16" 4-5/16"
4-5/16" 4-5/16"
(102mm) (102mm)
(102mm) (102mm)
H
Place the mounting blocks (H ) centered on the marks you just created.
Use a pencil to mark the center of the toilet drain flange using a straight edge.
Use a drill to fasten large lag bolts (I) into mounting blocks. Make sure drilled holes
Measure 4-5/16" (102mm) from center on either side of the flange.
will not interfere with screws, power lines, etc. below floor. NOTE: If mounting to
concrete floor, alternative fasteners may be required (not included).
3
4
E
K
Place a wax ring (K) on the toilet drain flange
Install the T-Valve (E) to the water shutoff.
and ensure the wax ring is centered over the hole.