ISC Rocker Instrucciones De Uso página 2

Instructions for use
• Use a locking karabiner to connect the Rocker to the attachment point. This may be the sternal attachment of
the user's harness, or an anchor.
• Swivel open the front plate whilst keeping the rear plate connected to the karabiner.
• Insert the rope between the 2 cams, ensuring that the pictogram of the person is pointing upwards, or towards
the load. Fig 3
• Swivel the front plate closed and connect both holes with the karabiner. Check the karabiner is locked.
• Carry out a function test by sliding the Rocker up the rope, and then checking it locks onto the rope in the
opposite direction.
• The Rocker can be parked in position by activating the thumb catch. This is operated by simply pushing the
catch downwards, and can be deactivated by pushing the catch back into place.
• Although the tests for these EN Standards are carried out using a one metre lanyard, ISC strongly recommends
that the Rocker is connected directly to the user's harness, or that the lanyard is as short as possible. The
maximum recommended lanyard length is 20cm plus standard sized connectors. The Rocker must remain in
reach of the user
2
– Installing on the rope:
Fig 1
Fig 5
Fig 7
Fig 2
Fig 4
Fig 6