EINHELL GE-PS 18/15 Li BL Manual De Instrucciones Original página 26

11. Troubleshooting
Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if
your tool fails to work properly. If the problem still persists after working through the list then please con-
tact your nearest service workshop.
Cause
The chainsaw does
not work at all
The chainsaw works
intermittently
The saw chain is
dry
The chain brake
does not work
The chain/guide rail
is hot
The chainsaw
judders, vibrates
or does not saw
properly
Anl_GE-PS_18-15_Li_BL_Solo_SPK13.indb 26 Anl_GE-PS_18-15_Li_BL_Solo_SPK13.indb 26
GB
Fault
- No power supply
- Loose connection (internal)
- On/Off switch defective
- No oil has been applied
- There is a problem with the switch
mechanism in the front hand guard
- No oil has been applied
- The chain is blunt
- The chain is too slack
- The chain is blunt
- The chain is worn
- The saw teeth are pointing in the
wrong direction
- 26 -
Remedy
- Check the rechargeable battery
- Consult a specialist workshop
- Consult a specialist workshop
- Apply some oil
- Consult a specialist workshop
- Apply some oil
- Re-sharpen or replace the chain
- Adjust the chain tension
- Re-sharpen or replace the chain
- Replace the chain
- Refi t the chain with the teeth facing
in the correct direction
03.05.2023 15:22:31 03.05.2023 15:22:31