MAHLE Digital ADAS Manual De Instalación página 23

7.7
Digital target assembly
The structure must be raised/lowered to an easy
height for the installer. The digital target is already
equipped with support bars.
Make sure you have temporarily
removed the knobs on the back of
the digital target before proceed-
ing with the assembly operations.
Store the accessories of the digi-
tal target that are not necessary
for this installation (support foot,
etc.). Store the packaging and the
manual. Keep the remote control
available making sure batteries are
installed.
Digital target assembly
1 Open the carton by removing the
blocks
2 Connect the power cord to the digital
target
3 Place the vertical bars on the support
rail between the special teeth
4 Slide the digital target until the thread-
ed holes for the knobs line up with the
holes in the panel
5 Insert the knobs inside the accessory
box (B) and screw them
6 Remove the labels and protective films
7 Connect the HDMI cable from the
Digital ADAS CPU to the digital target
8 Plug the power cord of the digital
target into the power outlet
23