MAHLE Digital ADAS Manual De Instalación página 26

26
Digital ADAS
Installation manual
7.9
Mirror assembly
Tools needed:
Phillips screwdriver
n
10 mm Allen key
n
In calibration operations where the
mirror is not necessary and where
the vehicle must be very close to
the Digital ADAS, it is recommend-
ed to remove the mirror.
The mirror must be kept clean with
a neutral detergent.
Mirror assembly
1 Unpack the mirror and its holder
2 Place the mirror support in the base
on the metric bar. Tighten the lower
handwheel
3 Place the mirror on the holder
Note: the mirror must be positioned
so that the lower distance between
hole and edge is at the bottom
4 Insert the 4 screws supplied in the
holes of the mirror and screw them to
the support, using a 3 mm Allen key
Note: tightening torque: 1.5 Nm
5 Remove the protective film from the
mirror