Publicidad
Idiomas disponibles
Idiomas disponibles
Safety and operating instructions
Before starting maintenance on the machine, clean
♦
it in order to avoid exposure to hazard substances.
See "Dust and fume hazards"
Use only authorised parts. Any damage or
♦
malfunction caused by the use of unauthorised
parts is not covered by warranty or product liability.
When cleaning mechanical parts with solvent,
♦
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦
For major service to the machine, contact your
nearest authorised workshop.
After each service, check that the machine's
♦
vibration level is normal. If not, contact your
nearest authorised workshop.
Every day
Before undertaking any maintenance on hydraulic
machines, always switch off the oil supply and bleed
the machine by depressing the start and stop device
Then disconnect the hydraulic hose from the
machine.
Clean and inspect the machine and its functions
♦
each day before the work commences.
Check if the spindle thread, the guard (the disc
♦
may not touch the guard) and the flange are in
good condition.
Conduct a general inspection for leaks, damage,
♦
and wear.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Make sure that all the attached and related
♦
equipment, such as hoses and flow dividers are
properly maintained.
If the machine has been dropped, carefully
♦
examine the disc.
♦
Ensure that the disc dimensions are compatible
and that it fits the spindle.
♦
Always plug hoses and nipples with clean and
tight plugs when dismounting.
♦
Check tightness of nuts, bolts, screws and hose
fittings after the first days of operation and
thereafter in accordance with the maintenance
schedule.
18
Every three month
♦
Check tightness of nuts, bolts, screws and hose
fittings.
Every 300 hours of operation
or every year
Check moving parts, seals and bolts for wear and
♦
cracks. Replace if necessary.
Check the function of the machine.
♦
Storage
Check that the machine is properly cleaned before
♦
storage.
Store the machine in a dry place.
♦
Keep the machine and tools in a safe place, out
♦
of the reach of children and locked up.
Disposal
A used machine must be treated and scrapped in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible.
Before a used machine is scrapped it must be
emptied and cleaned from all hydraulic oil. The
remaining hydraulic oil must be deposited and any
negative influence on the environment is to be kept
as low as possible.
© 2010 Atlas Copco Construction Tools AB | No. 3392 5042 90b | 2010-01-01
LS 14, 16, Cart
Original instructions
Publicidad
