Publicidad
Idiomas disponibles
Idiomas disponibles
LS 14, 16, Cart
WARNING Hydraulic oil at high pressure
Thin jets of hydraulic oil under high pressure can
penetrate the skin and cause permanent damage.
Immediately consult a doctor if hydraulic oil has
►
penetrated the skin.
►
Never use your fingers to check for hydraulic fluid
leaks.
►
Keep your face away from any possible leaks.
WARNING Hydraulic oil
Spilled hydraulic oil can cause burns, accidents due
to slippery conditions and will also harm the
environment.
Take care of all spilled oil and handle it according
►
to your safety and environmental regulations.
►
Never dismount the hydraulic machine when the
hydraulic oil is hot.
Never run any hydraulic lines for attachment of
►
the hydraulic machine through the drivers cab.
CAUTION Skin eczema
Hydraulic oil can cause eczema if it comes in contact
with the skin.
►
Avoid getting hydraulic oil on your hands.
Always use protective gloves when working with
►
hydraulic oil.
Wash hands after contact with hydraulic oil.
►
Operation, precautions
WARNING Operating pressure
If the maximum operating pressure for the hydraulic
machine is exceeded, it can result in material
damage and personal injury.
Always run the hydraulic machine with the correct
►
operating pressure. See "Technical data".
DANGER Explosion hazard
If an insertion tool comes into contact with explosives
or explosive gases, an explosion could occur. When
working on certain materials and when using certain
materials in machine parts, sparks and ignition can
occur. Explosions will lead to severe injuries or death.
►
Never operate the machine in any explosive
environment.
Never use the machine near flammable materials,
►
fumes or dust.
►
Make sure that there are no undetected sources
of gas or explosives.
© 2010 Atlas Copco Construction Tools AB | No. 3392 5042 90b | 2010-01-01
Original instructions
Safety and operating instructions
WARNING Unexpected movements
The machine and the cutting blade might kick back
towards the operator very suddenly and violently. If
the upper quadrant of the blade touches an object,
the cutting blade might move and may cause serious
injury. To reduce risks:
Never use the equipment if you suspect that it is
►
damaged.
Never start to cut with the upper quadrant of the
►
cutting blade.
►
Always hold onto the machine with both hands
and make sure the cutting blade is away from your
body.
Keep a good balance and a firm foothold.
►
Always cut with the machine running at maximum
►
speed.
►
Make sure that the work piece is supported during
cutting.
Be careful when inserting the blade in the
►
machine.
Never cut above shoulder height.
►
►
Never cut in wood.
Never place the machine on the ground, before
►
the blade has come to a complete stop.
Never strike or abuse the equipment.
►
9
Publicidad
