Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking
Note: Before unpacking check the damage is whether due the transportation or not, if you find any
such damage, please do not use this item, and contact with the MARK PRO dealer.
1. Open the fly-case and take out the inside plastic bag.
2. High-lift the product by two handles beside the bottom base and move it out.
3. Make sure you have opened the X, Y axis lock and after that power on the unit.
Attention
One product just can accept one input one output.
BEAM 350 DMX cable includes 3 contact pins:
Pin 1: Ground
Pin 2: Connect it to the negative pin
Pin 3: Connect it to the positive pin
The DMX cable must use the professional shielded twisted pair cable. Standard loudspeaker cable is
not reliable to control the long-range data. 24AWG cable is suitable for more than 300 meters long-
distance signal transmission and must add\ DMX 512 signal amplifier. Do not use two outputs to
separate the connection, if you separate a continuous connection you will need to use a DMX splitter.
Don't overload the connection. One continuous connection can only support up to 30 devices.
If a DMX512 splitter is used, follow this instructions:
At first connect the DMX512 Splitter input terminal to controller. After that, connect it from the splitter
output terminal to next device. Do as above guide to connect other device and finally coupled with
terminal insertion. To prevent system errors, the last device in a DMX chain needs to be equipped with
a terminating resistor (120 ohm, 1/4 Watt).
5
Publicidad
